For those willing to try it loosening all the moutherboard mounting screws, giving the board a jiggle and retightening might well be enough to alter the position and stress on the bad joint and cure the problem. Solder is not actually a necessity to have a good joint in most cases pyhsical contact of clean metals should be enough and in my case, since my problem which was the same as everybody elses, has not reappeared after many cold starts it is reasonable certain that my giving the motherboard a good flex had made a high resistant joint good enough to perform with defective soldering: if the soldering was not defective the flexing would have made no difference. Would strongly advise taking soldering iron near motherboard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |